If this happens, and it is a hassle getting a new
A-arm, you could probably build up the worn area
around the hole
with a MIG or TIG welder, and restore the hole's
correct diameter. (But if you have to pay somebody to
do it, it
would probably be cheaper to just get a used A-arm).
Doug Braun
'72 Spit
--- Cwn74@aol.com wrote:
> If the bushings deteriorated so bad that the bolt
> enlarged the hole in the
> a-arms, you need to replace them also.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|