I'm getting to the point when I will be sand blasting and clean parts
on my chassis. What is a good way to go about this?
Will sand blasting remove most of the dirt and so on or do I need to
soak the parts first? I'm not going to buy a parts washer but if I
need to clean parts I might use a rough neck container seeing as I'm
out of space in my garage.
Also how should I go about sand blasting my shocks?
Is there any risk of damaging them?
A.
--
Andre Rousseau
1968 GT6 MK I - Ottawa
http://www.justdrive.ca/
andrer@mac.com
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|