OK, so most of you never use your hard-tops, so this won't be a problem to you,
but someone may have the answer...
Triumph, in their great wisdom, decided that our cars had no need of a
quarter-light on the door windows. As a result, there is not much to stop the
windows flapping in and out. As a result, my window leans out of the car,
just a little, but enough that it does not press snugly against the rubber
seal on the hard-top towards the top of the window. At speed, the passing air
outside the window sucks the window out a little further, and an unpleasant
little draught sneaks in around the gap and blasts the back of my neck.
So, my question is, is there any way of either stiffening the window against
its wobble (could there be a bit bit of looseness in the way the slider fits
in the guides?), and/or adjusting the whole thing so that it's natural angle
leans a bit more into the car, so that there is something to compress the
window against my (nice new) window seals?
I will get the trim panel off and have a look at the set-up, but I was just
wondering if anyone else has already been through this?
Richard and Daffy (them draughts is getting colder as November approaches...)
|