Jeremy;
After it stalls will it start up again right away?
(a bad CPS won't)
If it won't check codes right away, you may find a CPS code.
If it will, clear all codes and run codes again. Note which one sets
"first".
Deal with that one.
Check all grounds for tightness, especially ECM ground: screw on firewall
near neg batt, with wires from neg batt and ECM (thru quick disconnect).
Also important grounds on pass rear manifold bracket bolt way in back, and
pass firewall by hood strut, small blk ground & screw.
Clear codes and check again.
Lee
----- Original Message -----
From: "Jeremy" <jhallam@locl.net>
To: <shotimes@autox.team.net>
Sent: Saturday, July 15, 2006 3:01 PM
Subject: [Shotimes] Dies at idle when hot Help.
> Hello,
> I've been lurking for about a year..this is my first post. The problem
> that I am having is that my sho ('94 MTX) keep stalling on hot days after
> a
> driving period of about 1 hour or so. It seems to run fine, then if I let
> it
> sit an idle for about 1-3 minutes it stalls (almost like it is out of
> gas). I
> just did my 60K a couple of months ago, so I don't think it is the CPS. I
> also just cleaned the IAB with no luck. I pulled the codes and got these:
> 511-no power to PCM pin 1 or bad PCM
> 542- Fuel pump open/bad ground or always on
> 411- Idle speed system not controlling idle properly
> 225- Knock sensor not tested
>
> From these I am thinking that it probably has something to do with my fuel
> pump. Either it is bad, or not grounded. Am I on the right track, or way
> off?
>
> Jeremy
> '94 MTX y-pipe, LPM, K&N
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|