Initial ideas:
- Carve a wine bottle cork to fit?
- Make both holes round and use a rubber plug. I have something like
this in the floor of my GT6.
- Electrical knockout plug like
https://www.homedepot.com/p/Halex-1-in-Knockout-Seals-2-Pack-96073/100137466
- Have to mention duct tape.
- Stickers for your favorite car or tool company?
On 7/20/2022 5:38 PM, Scott Hall wrote:
> I have acquired a kegerator. It lives in the garage.
>
> (This has impacted my efficiency in the shop.)
>
> The previous owner drilled two holes in side of the unit for drain and
> gas lines. I don't have a floor drain, so my drain line is going to a
> bucket in the unit, and my gas tank lives in there, too.
>
> I finally got around to cleaning up those lines and now I have two
> irregular holes in the side of my kegerator, leaking out 34° air.
>
> Whomever did these was not interested in his workmanship. They're .5
> inch by .75 inch, more or less, so round plugs really don't work. The
> sheet metal is also pretty jagged. I thought about drilling then out
> to a uniform shape, but I really don't want to make them bigger.
>
> I could masking tape one side and spray foam them, but I'm hoping the
> outside could be a little more permanent.
>
> Anybody have thoughts? All opinions welcome.
>
> _______________________________________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/shop-talk/bk13@earthlink.net
>
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/mharc@autox.team.net
|