shop-talk
[Top] [All Lists]

Re: [Shop-talk] How to connect skewed beams?

To: "Jim Franklin" <jamesf@groupwbench.org>, "shop-talk" <shop-talk@autox.team.net>
Subject: Re: [Shop-talk] How to connect skewed beams?
From: "john niolon" <jniolon@att.net>
Date: Sun, 12 Jul 2020 12:14:23 -0500
Delivered-to: mharc@autox.team.net
Delivered-to: shop-talk@autox.team.net
References: <C715C1F2-FB32-498D-A29E-73D4E88A7FB5@groupwbench.org>
User-agent: OEClassic/3.1 (Win10.19041; P; 2020-06-10) (Java/11.0.7)
Jim,  do you have the ability to cut/weld/bend metal plate ?? just bend up your 
own "simpson strong tie" at what ever angle you need... you could even do an 
inside and outside... (inside would be tough)   or measure and cut a plate 
whatever length and width you need to place under the two beams on top of the 
post (4x6)  and drill the plate and screw in anchoring bolts/screws to the 2" 
edge.

john
----- Original Message -----
From: Jim Franklin <jamesf@groupwbench.org>
To: shop-talk <shop-talk@autox.team.net>
Sent: 7/12/2020 11:44:48 AM
Subject: [Shop-talk] How to connect skewed beams?
________________________________________________________________________________

Hope you're all avoiding the ridiculous heat. I am buidling a deck like the 
rest of the nation, so my tshirt tan will be well developed in a few weeks.

I'm trying to connect two double 2x beams to each other. They meet at about 33 
degrees from parallel. Simpson doesn't have anything that I can find that works 
outside the 45-90 range. Since any fasteners will be near the end of the angled 
beam, I'm hesitant to drive something like Ledger Loks through for fear of 
splitting it. I don't have a way to support it from underneath, it can only 
hang from the main beam with a hanger that clamps over the top, or be face 
connected in shear. The angled beam is 8.5' long so it will have significant 
weight on it if the deck ever sees people. 

The other end of the angled beam isn't built yet, and it will be resting on its 
own post, so I could splay them such that the end in question uses two separate 
single beam connectors, but I come up empty there too except for a bendable 
angle bracket that I won't be able to fasten on the inside angle:

http://embed.widencdn.net/pdf/plus/ssttoolbox/8yq2wqljay/C-C-2019-p284.pdf

The other option is to have them meet at their cut faces over a post, but the 
post is a 4x6 and I don't know if that would be enough purchase to provide 
support. I would have to fasten everything into the post; there is no 
post-to-beam connector for beams meeting at 33 degrees.

thanks,
jim
_______________________________________________

Shop-talk@autox.team.net
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive

_______________________________________________

Shop-talk@autox.team.net
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive



<Prev in Thread] Current Thread [Next in Thread>