You could clamp a 4 x4 to the rear edge of the boards. Then with the
circular saw set at 30 degrees, put the saw base against the rear face of
the 4 x4.
Greg G.
Osseo, MN
> I decided to go with 2x8s as my trailer deck, but having an abrupt edge
> would
> make loading wheeled things annoying. I'd like to bevel the edge to match
> the
> deployed ramp, about 60 degrees (relative to the butt end). My circular,
> table, and chop saws all stop at 45. I don't have access to a band saw.
> Any
> ideas on how to get over to 60?
>
> There are 8 boards, so things like belt sanding from a 45, or using a
> capricious hand saw are a last resort :-)
> _______________________________________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/shop-talk/greg@gelhar.com
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/archive
|