I set out to do exactly what you are describing. After cutting into the tank
to assess how far the damage propagated out, I found that all I needed was a
very small patch. It has been working fine.
Sent from my iPhone
On Oct 3, 2013, at 10:33 AM, Gil Fuqua <Gil.Fuqua@cci-ir.com> wrote:
> I have a 5hp industrial compressor with an 80 gallon tank that developed a
> pinhole leak on the bottom (horizontal leak). The tank has an automatic
drain
> that cycles each time the compressor comes on; however, I don't use it much
> and residual moisture has probably rusted through on the bottom.
>
> I thought about welding a plate across the entire bottom since I suspect
other
> leaks will appear over time. I would like to keep it if possible since the
> compressor is still good.
>
> Anyone have any success in repairing a compressor tank?
>
> Gil
> Nashville
> _______________________________________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/james.f.juhas@snet.net
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/archive
|