shop-talk
[Top] [All Lists]

Re: [Shop-talk] tie rods

To: Shop Talk <shop-talk@autox.team.net>
Subject: Re: [Shop-talk] tie rods
From: Tim <tputland@charter.net>
Date: Sat, 29 Sep 2012 16:36:42 -0400 (EDT)
Delivered-to: shop-talk-archive@autox.team.net
Delivered-to: shop-talk@autox.team.net
User-agent: Laszlo Mail 3
Well, I am an idiot and freely admit it with my hand held high.

The new ones have the same length ball joint end threads. The old ones 
didn't. I thought I had the new outer since the threaded end of the new 
one looked longer than the other new one. Once I realized it was not the 
outer end, it went right together.

Free idiot training here from the master.

tim

On Sat, Sep 29, 2012 at 1:57 PM, Tim wrote:

> I just bought new sleeves and it still won't thread straight. Threads 
> on the rod end are not crossed...WTF am I going wrong?
>
>
> On Sat, Sep 29, 2012 at 1:45 PM, ejrussell@mebtel.net wrote:
>
>> Quoting Tim <tputland@charter.net>:
>>> Is there a trick to getting a new tie rod into the adjustment 
>>> sleeve? I
>>> cannot, for the life of me, get the new tie rod end to start 
>>> threading
>>> straight. It goes crooked on the first turn, everytime time.
>>
>> You likely need to 'chase' the threads. Once cross-threaded it will 
>> tend to follow that thread each time you try to assemble it (and get 
>> worse each time, too). Best would be to get a re-threading tap/die - 
>> less chance of cutting new (incorrect) threads. This is assuming the 
>> new part has the correct threads. Will the old tie rod thread back on 
>> OK?
>>
>> Eric Russell
>> Mebane, NC
> _______________________________________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/shop-talk/tputland@charter.net
_______________________________________________

Shop-talk@autox.team.net
Archive: http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>