shop-talk
[Top] [All Lists]

[Shop-talk] PVC patching.

To: <shop-talk@autox.team.net>
Subject: [Shop-talk] PVC patching.
From: "Mark Miller" <markmiller@threeboysfarm.com>
Date: Tue, 26 May 2009 18:44:56 -0700
so, anybody know of either a pvc cement that can be applied and used while
the pieces are wet, or else a way to plug large pvc lines internally, then
remove the plug after a fitting is installed? the fittings are union
fittings and ball valves, so I'll be within a few inches of the plug, but
the hole it has to come out is a good bit smaller than the i.d. of the pipe.



If the water isn't under pressure you could just take the caps off for a day
or two and wait for physics to run its course; sooner or later it will be
done.
Or: stick a balloon down the pipe, one of those long make a dog kind.  And
pop it once the union is in.  

Mark M
Sebastopol
I do believe in gravity, I do I do I do...
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


Shop-talk mailing list

http://autox.team.net/mailman/listinfo/shop-talk

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>