And as long as I was googling about chainsaw bars - this site
http://www.lowes.com/lowes/lkn?action=howTo&p=LawnGarden/MaintainingChainsaw.html#11
recommends that you flip the bar over - which might just be enough to fix
your problem.
----- Original Message -----
From: "Eric J Russell" <ejrussell@mebtel.net>
To: "shop-talk" <shop-talk@autox.team.net>
Sent: Wednesday, May 13, 2009 5:48 PM
Subject: [Shop-talk] chain saw cuts curves...?
> My 16" Craftsman chain saw is cutting curves. The blade is wandering to
> the
> left. After an inch or two, the blade binds and I can't complete a cut. I
> tried replacing the chain (one that had been re-sharpened at a local
> hardware
> store) thinking that perhaps the 'teeth' had been damaged along one side
> but
> that has not fixed it. I suppose I could have two defective chains but,
> before
> I buy a new chain, is there something else I am missing?
>
> In case my description is inadequate, while attempting to cut some
> landscape
> timbers for a retaining wall, the cut is straight across top of the timber
> but
> looks like a comma on the vertical side of the timber.
>
> Eric Russell
> Mebane, NC
> http://home.mebtel.net/~ejrussell
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as arvidj@visi.com
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|