shop-talk
[Top] [All Lists]

welding question

To: Shop Talk <shop-talk@autox.team.net>
Subject: welding question
From: dms@scheidt.chem.nd.edu
Date: Fri, 12 Apr 2002 19:05:50 -0500 (EST)
I need to weld a 1/2" square rod to a plate, rotated by 45 deg from the flat
side.  In other words, by the edge.  I need to be pretty accurate about it, 
and I'm not quite sure how to clamp it in place, and how to make sure it's
square.  What I've considered doing is grinding or gouging a groove in the
plate, and perhaps grinding the corner a bit so it's not quite so pointy.
I'm concerned that I'll lose more height than I'd really like doing it that
way.  Any other suggestions?

Thanks

David 

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/shop-talk


<Prev in Thread] Current Thread [Next in Thread>