oletrucks
[Top] [All Lists]

RE: [oletrucks] Steering Box Leak

To: "Charles Hosang" <hosang1@earthlink.net>,
Subject: RE: [oletrucks] Steering Box Leak
From: "Hanlon, Bill (ISS Houston)" <Bill.Hanlon@hp.com>
Date: Thu, 15 Sep 2005 14:05:04 -0500
The "new" steering box that I put into my '57 GMC 1/2 ton last year had
a seal on the end of the sector shaft that the pitman arm mounted to.
It was sort of a thin metal enclosure that held a felt seal that I guess
could be referred to as "packing".  I replaced the whole thing with GM
part number 7801626.  It hasn't leaked a drop since on my daily driver.

Description of the part in the GMC Master Parts Book is:
        16.0780  Retainer - Steering Gear Pitman Shaft Gasket  
        part # 262156 used on all 1/2-1 tone pickups.  
        1.411" OD x 1 3/16" ID x 1/4" thick
Picture in the book looks like it is packed with felt to me.

Here are excerpts from a discussion a year or two ago about this seal:


Nate - sorry I didn't see this earlier. My seal on my 53 GMC 1/2 ton was
Federal Mogul #313842. I just took the original packing in and the
counter guy matched it with the seal. I usually write down the
dimensions but didn't in this case. Also I haven't installed any lube
yet, so I don't know how it will work. Seemed right at installation.
Goodntight.

Thanx , I ordered up a couple and will see how they work . 
I also found the original GM part # , it's the same seal for '47 ~ '70
manual steering boxes in 1/2 ton pickups so they had it in stock . 
-Nate

O.K. , here is the original GM steering box sector shaft oil seal part
number : 
7801626 
BTW : this fits from 193? to 1970 + so you might want to keep a note of
it , pencil it in the margin of your shop manual , this is the very best
quality seal you can get so i'd buy one NOW whilst GM still makes it . 
-Nate


By the way, list member Nate was right on the money about the sector
shaft seal.  It is still available from GM as part number 7801626 at
about $14 a pop.  There were only 2 dealers in Texas that had one on the
shelf.  Federal-Mogul (National Seal) part # 313842 was available in the
local warehouse for my FLAPS, was delivered that afternoon and cost
$6.49.  This is a "rubber" seal, not like the felt seal I removed from
the steering box.  The GM part is also a "rubber" seal.

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959





<Prev in Thread] Current Thread [Next in Thread>