oletrucks
[Top] [All Lists]

Re: [oletrucks] advice on rust treatments

To: "Gary R. Schwarzrock" <gschwarz@airtimeisp.net>
Subject: Re: [oletrucks] advice on rust treatments
From: JOE GARCIA <joegarcia1@comcast.net>
Date: Sun, 13 Jul 2003 18:36:02 -0700
I like using the Eastwood "Oxisolv" as well as their "Rust ncapsulator".

A friend of mine found me a few AD Cabs a while back "they were about 
to go to the crusher" so I took them home.  They all need cab corners 
and one needs a complete floor and one was a 5-window with a very bad 
dash and front floor and firewall section.  I melted the lead on the A-
pillar seam and then cut the floor through the rockers from one side to 
the other just in front of the seat riser.  I mated the 5-window with 
the good dash and front floor section of the other truck to make a good 
5-window.  I won't even tell you what plans I have for the 
cab's "custom wise" because the majority on the list would go into 
shock.  Yeah, I'm one of those hackers who does  the chopping and 
suicide door and other unmentionables to the AD's but like I said these 
cabs were heading to the wrecking yard to be crushed so don't feel to 
bad for them.

Another friend just gave me a really nice 1950 bed with back fenders as 
a trade for me welding in some cab corners on his truck.

Joe



----- Original Message -----
From: "Gary R. Schwarzrock" <gschwarz@airtimeisp.net>
Date: Sunday, July 13, 2003 11:35 am
Subject: [oletrucks] advice on rust treatments

> Does anyone have any good or bad comments on rust treatments?   
> There are
> three products that I have seen mentioned:
> 
>                    Eastwood "corolless"
>                    POR-15
>                    Rust Bullet
> 
> And a second thought.  Has anyone thought of or tried to make a 5 
> window cab
> by cutting the window ports out of a thrashed deluxe cab and 
> grafting them
> into a good cab?  My thought was to cut the windows out right 
> where the
> rubber molding is on the outside with the thought that the drop 
> into the
> window hole and some "careful welding" might control the warpage, 
> and then
> cut the inside close to the door post and the rear window to get some
> support for the weld seams on the inside.
> 
> Thanks,
> 
> Gary  1954 Chev 3100
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 
> 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>