No need to change gears. Just remove the mounting collar (hacksaw/file
operation) then put the distributors side by side and grind/file the HEI
tang to the same profile as the old distributor. Use the 235 clamp, run 10
ga wire from the switch to the hot post and you're done.
Jack
www.inliners.org
----- Original Message -----
From: <SnotMe80@aol.com>
To: <oletrucks@autox.team.net>
Sent: Wednesday, November 20, 2002 10:26 PM
Subject: [oletrucks] hei distributor questions
> i have a hei distributor out of chevy inline six from a chevy 250. i am
> wanting to put it in my 54 235 2 ton truck-i know i have to do a little
> machineing to get it to fit but do i need a different gear on the
> distributor? do i use the one on the hei or do i take it off the old
points
> distributor? thanks
> Rob
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|