oletrucks
[Top] [All Lists]

Re: [oletrucks] TF Rear End Rebuild Parts

To: "OLETRUCK list" <oletrucks@autox.team.net>,
Subject: Re: [oletrucks] TF Rear End Rebuild Parts
From: "Boteler" <boteler@olg.com>
Date: Mon, 9 Sep 2002 23:53:36 -0400
You should be able to get all of the brake/bearing parts from NAPA.

Good Luck,
Mike Boteler
'56 8400 Wrecker


----- Original Message -----
From: "Carl & Becky Ham" <the_hams@hotmail.com>
To: <oletrucks@autox.team.net>
Sent: Sunday, September 08, 2002 8:42 PM
Subject: [oletrucks] TF Rear End Rebuild Parts


> Just got my '56 Chevy 1/2 ton back on the road after 3 months of work.
> After driving it for several miles at highway speed (40-60 MPH), I've
> noticed the driver's side rear brake drum (repainted during my earlier
work)
> has most the paint burnt-off and the drum/wheel is hot enough to fry eggs
on
> after a short trip.  I loosened the brake adjusters on the drum but it
still
> gets hot after a short drive.  My truck has the stock rear end with either
> 3.90 or 4.11 ratio.
>
> I'm going to pull both rear wheels and drums tomorrow and I'm hoping the
> problem is the brakes.  But if it is not, does anyone know how difficult
it
> might be to buy new rear axle bearings and where I might get a set?
> Appreciate any advice and thanks in advance.
>
> Carl Ham
> '56 Chevy TF Stepside
> Pontiac, IL
>
>
> _________________________________________________________________
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>