In a message dated 9/28/00 7:38:30 PM Central Daylight Time,
bmdumkee@auroranet.nt.ca writes:
<< My only thought at this time is to get the welder at work to cut/grind this
piece from one and weld it on the other. Any thoughts on this idea? >>
Is the diameter big enough to drill and tap so it could be bolted throught
the backing plate? Welding would likely be the stronger choice, especially
if the bolt were less then 5/16".
Mike Klepp
'48 3100
Wichita Falls, TX
http://www.geocities.com/mike_klepp/septruckpage.html
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|