Since a visor is curved in two planes & is cut on a curve on the top, bottom
& sides, this is hard to measure. If you are looking for measurements to
check for possible matches for your truck, check the distances between the
doors (right over the top of the windshield) for the width. Length
(actually the width of the visor, but running the length of the truck) is
about 18" or so (not as critical & usually adjustable, as to how much shade
you want).
Regards,
Doug Pewterbaugh
dpewter@msn.com
Denton, TX
49 3104 216 5-window
----- Original Message -----
From: Jeff Davis <jsd51@hotmail.com>
To: <oletrucks@autox.team.net>
Sent: Wednesday, September 27, 2000 5:57 PM
Subject: [oletrucks] Visor deminsions
> Asked this very question yeaterday but recieved no answers so I
thought
> I'd try again. Can someone please give me the length and width (in inches)
> of the visor for an AD? Thanks.
>
> Jeff Davis
> '51 3100
> '66 C10
>
> P.S. Thanks for all the suggestions on the "finicky carb.".
> _________________________________________________________________________
>
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|