That is the correct method of installing the plate.
When I installed 3-Point seat belts in my brothers truck, I also drilled
holes in the door pillar and installed square tubing up through the back and
plug welded it to the pillar. Then I added a fish plate from the tubing to
the floor for added support.
Just an added precaution, because you never know!
Joe
----- Original Message -----
From: Stephen <slb1@humboldt1.com>
To: Chevy Trucks <oletrucks@autox.team.net>
Sent: Thursday, March 02, 2000 10:59 PM
Subject: [oletrucks] 3-Point seat belt installation question
> I am installing Juliano 3-point seat belts in my '58 Fleetside. Juliano's
> told me to cut out a section of the door pillar outer surface the exact
size
> of the mounting plate. Then weld in the plate so in fits flush to the
> surface. Is this correct or is there something more solid deeper in the
> pillar to weld the plate to?
>
> Thanks,
>
> Stephen
> '49 GMC Panel
> '50 Chevy Suburban
> '58 Chevy Fleetside
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|