Thanks, Paul, I'll let you know how it goes. And thanks to all the other
ole truckers who have come to my rescue with this problem again and again!
Smokey
'50 3600 5-window
-----Original Message-----
From: Hudson29@aol.com <Hudson29@aol.com>
To: sculver@iwl.net <sculver@iwl.net>; oletrucks@autox.team.net
<oletrucks@autox.team.net>
Date: Friday, July 09, 1999 3:55 PM
Subject: Don't Give Up Smokey!
> Check to make sure you have your test meter set correctly. I had
>problems recently and thanks to tips posted here on this list, was able to
>verify my sending unit using an old Radio Shack multimeter set to measure
>ohms. To briefly recap, my unit measured 1.5 ohms with the float down, and
>33.5 ohms with the float fully up. I ran a new ground wire to the seat base
>and that seems to have fixed the problem.
> The gauge needle now comes off of the bottom stop and does not peg
>itself on the top stop. There have been some great suggestions here so let
us
>know how you make out!
>
>Paul O'Neil, Hudson29@aol.com
>1951 Chevrolet 3600 Pickup Project, See it at:
>The Poor Man's Advanced Design Tech Tips Page
>http://home.earthlink.net/~conntest47/
>Fullerton, California USA
>AEROMARK - Need Rubber Stamps or Signs? See:
>http://hometown.aol.com/hudson29/myhomepage/index.html
>
>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|