--===============7478189661454854545==
boundary="----=_Part_754595_478834349.1473207978904"
------=_Part_754595_478834349.1473207978904
Content-Transfer-Encoding: quoted-printable
Ok, tried removing the brake booster vacuum hose with no change.....
I removed it at the manifold end as it was a lot easier to get to - plugged=
the port there. Car ran the same when started, however revs increased noti=
ceably when I removed theplug while the car was running. Still ran roughly =
but not quite as badly and with increased vigor, it seemed to me. And the h=
ose was completely dry as far up as I could reach witha swab. I then hooked=
it up, ran the car again, and then checked inside the hose again - still d=
ry.....
I'll worry about the brake fluid loss once I get the car up and running aga=
in.... Didn't seem like the reservoir was any lower today after running the=
car a bit yesterday....
Any thoughts on what to check next?
Thx, Dan
From: PaulHunt73 via Mgs <mgs@autox.team.net>
To: MG-MGB@yahoogroups.com=20
Cc: MG List <mgs@autox.team.net>
Sent: Tuesday, September 6, 2016 8:17 AM
Subject: Re: [Mgs] [MG-MGB] Rough Running
=20
Yes.=C2=A0 It would only be wet if it is sucking brake fluid past a faulty=
seal in the servo.=C2=A0PaulH.=C2=A0
----- Original Message ----- Ok, thanks, guys, will check this tonight. I=
assume that this is simply providing vacuum to the booster and should be d=
ry normally...? =20
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/d_dibiase@yahoo.com
=20
------=_Part_754595_478834349.1473207978904
Content-Transfer-Encoding: quoted-printable
<html><head></head><body><div style=3D"color:#000; background-color:#fff; f=
ont-family:HelveticaNeue, Helvetica Neue, Helvetica, Arial, Lucida Grande, =
sans-serif;font-size:13px"><div id=3D"yui_3_16_0_ym19_1_1473192723955_22948=
">Ok, tried removing the brake booster vacuum hose with no change.....</div=
><div id=3D"yui_3_16_0_ym19_1_1473192723955_22971"><br></div><div id=3D"yui=
_3_16_0_ym19_1_1473192723955_22972" dir=3D"ltr">I removed it at the manifol=
d end as it was a lot easier to get to - plugged the port there. Car ran th=
e same when started, however revs increased noticeably when I removed the</=
div><div id=3D"yui_3_16_0_ym19_1_1473192723955_22949" dir=3D"ltr">plug whil=
e the car was running. Still ran roughly but not quite as badly and with in=
creased vigor, it seemed to me. And the hose was completely dry as far up a=
s I could reach with</div><div id=3D"yui_3_16_0_ym19_1_1473192723955_22955"=
dir=3D"ltr">a swab. I then hooked it up, ran the car again, and then check=
ed inside the hose again - still dry.....</div><div id=3D"yui_3_16_0_ym19_1=
_1473192723955_22950" dir=3D"ltr"><br></div><div dir=3D"ltr">I'll worry abo=
ut the brake fluid loss once I get the car up and running again.... Didn't =
seem like the reservoir was any lower today after running the car a bit yes=
terday....</div><div id=3D"yui_3_16_0_ym19_1_1473192723955_22951" dir=3D"lt=
r"><br></div><div id=3D"yui_3_16_0_ym19_1_1473192723955_22952" dir=3D"ltr">=
Any thoughts on what to check next?</div><div id=3D"yui_3_16_0_ym19_1_14731=
92723955_22953" dir=3D"ltr"><br></div><div id=3D"yui_3_16_0_ym19_1_14731927=
23955_22973" dir=3D"ltr">Thx, Dan<br></div><div id=3D"yui_3_16_0_ym19_1_147=
3192723955_22974"><span></span></div><div id=3D"yui_3_16_0_ym19_1_147319272=
3955_22975" class=3D"qtdSeparateBR"><br><br></div><div style=3D"display: bl=
ock;" id=3D"yui_3_16_0_ym19_1_1473192723955_22979" class=3D"yahoo_quoted"> =
<div id=3D"yui_3_16_0_ym19_1_1473192723955_22978" style=3D"font-family: He=
lveticaNeue, Helvetica Neue, Helvetica, Arial, Lucida Grande, sans-serif; f=
ont-size: 13px;"> <div id=3D"yui_3_16_0_ym19_1_1473192723955_22977" style=
=3D"font-family: HelveticaNeue, Helvetica Neue, Helvetica, Arial, Lucida Gr=
ande, sans-serif; font-size: 16px;"> <div id=3D"yui_3_16_0_ym19_1_147319272=
3955_22976" dir=3D"ltr"> <font id=3D"yui_3_16_0_ym19_1_1473192723955_22994"=
size=3D"2" face=3D"Arial"> <hr size=3D"1"> <b><span style=3D"font-weight:b=
old;">From:</span></b> PaulHunt73 via Mgs <mgs@autox.team.net><br> <b=
><span style=3D"font-weight: bold;">To:</span></b> MG-MGB@yahoogroups.com <=
br><b><span style=3D"font-weight: bold;">Cc:</span></b> MG List <mgs@aut=
ox.team.net><br> <b><span style=3D"font-weight: bold;">Sent:</span></b> =
Tuesday, September 6, 2016 8:17 AM<br> <b><span style=3D"font-weight: bold;=
">Subject:</span></b> Re: [Mgs] [MG-MGB] Rough Running<br> </font> </div> <=
div id=3D"yui_3_16_0_ym19_1_1473192723955_22998" class=3D"y_msg_container">=
<br><div id=3D"yiv2251286953">
=20
=20
<style></style>
<div id=3D"yui_3_16_0_ym19_1_1473192723955_23000">
<div id=3D"yui_3_16_0_ym19_1_1473192723955_22999"><font id=3D"yui_3_16_0_ym=
19_1_1473192723955_23001" size=3D"2">Yes. It would only be wet if it =
is sucking brake fluid=20
past a faulty seal in the servo.</font></div>
<div id=3D"yui_3_16_0_ym19_1_1473192723955_23002"><font size=3D"2"></font>&=
nbsp;</div>
<div><font size=3D"2">PaulH.</font></div>
<div><font size=3D"2"></font> </div>
<blockquote style=3D"BORDER-LEFT:#000000 2px solid;PADDING-LEFT:5px;PADDING=
-RIGHT:0px;MARGIN-LEFT:5px;MARGIN-RIGHT:0px;">
<div style=3D"FONT:10pt arial;">----- Original Message ----- </div>
<div>Ok, thanks, guys, will check this tonight. I assume that this is sim=
ply=20
providing vacuum to the booster and should be dry normally...?</div>
<div style=3D"POSITION:relative;" id=3D"yiv2251286953ygrp-mlmsg">
<div style=3D"Z-INDEX:1;" id=3D"yiv2251286953ygrp-msg">
<div id=3D"yiv2251286953ygrp-text">
<div style=3D"BACKGROUND-COLOR:#fff;FONT-FAMILY:HelveticaNeue, Helvetica =
Neue, Helvetica, Arial, Lucida Grande, sans-serif;COLOR:#000;FONT-SIZE:13px=
;">
<div><br></div></div></div></div></div></blockquote></div></div><br>_____=
__________________________________________<br><br><a ymailto=3D"mailto:Mgs@=
autox.team.net" href=3D"mailto:Mgs@autox.team.net";>Mgs@autox.team.net</a><b=
r>Donate: <a href=3D"http://www.team.net/donate.html"; target=3D"_blank">htt=
p://www.team.net/donate.html</a><br>Suggested annual donation $12.75<=
br>Archive: <a href=3D"http://www.team.net/archive"; target=3D"_blank">http:=
//www.team.net/archive</a><br>Forums: <a href=3D"http://www.team.net/forums=
" target=3D"_blank">http://www.team.net/forums</a><br>Unsubscribe: <a href=
=3D"http://autox.team.net/mailman/options/mgs/d_dibiase@yahoo.com"; target=
=3D"_blank">http://autox.team.net/mailman/options/mgs/d_dibiase@yahoo.com</=
a><br><br><br></div> </div> </div> </div></div></body></html>
------=_Part_754595_478834349.1473207978904--
--===============7478189661454854545==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
--===============7478189661454854545==--
|