I would not do this.
You have no idea of the condition of the rest of the walls of the
compressor. Patch one pin hole and you might then get a catastrophic
failure of the entire tank.
A pressure vessel with a rust hole is scrap IMHO.
Rick
On Thu, Aug 16, 2012 at 11:46 AM, <DMatt21502@aol.com> wrote:
> If the hole is just pinhole size I would try sanding around it and using JB
> Weld. Mine has held for 20 years!
> _______________________________________________
>
> Mgs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/mgs/richard.ewald@gmail.com
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/mgs/mgs-archive@autox.team.net
|