And the point to my question on the subject, several days ago, was where or
how to attach the seat belts when the inner sill has been replaced. I was
relatively certain that the attachment point was located there for my 72B
even though my only available reference was two pre-67 cars. I suppose I
could bore a large hole and insert one of the spreading nut type of
devices. Certainly someone here has had to fabricate an attachment point
after inner sill replacement? Is there a more eloquent way or any suggestions?
David Councill
67 BGT
72 B
At 10:30 AM 5/6/2003 +0100, Telewest \(PH\) wrote:
>You should have welded-in threaded bosses on the tunnel and inner
>square-section sill, but those on the inner sill may have been missed out if
>that section has been replaced.
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|