Re: aluminum head for mgb

[Max Heim <mvheim@studiolimage.com>]

Just a suggestion -- run the sling diagonally from a front motor mount on 
one side to a bell housing bolt on the other side. The chain might scrape 
a little paint on the block but I've done it that way, not wanting to 
tweak the studs.

Andrew B. Lundgren had this to say:

>Now I am not sure how to pull the engine, but I will figure that out when 
>I go to put the OD in.


--

Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the red one with the silver bootlid.