I'll second what robmgb suggested. This works for me. Apparently only the
very early racks had a zerk fitting at all. Mine is a '68 and has no such
fitting. Just loosen the clamp on the boot ( I went in between the tie rod
and the boot) and pump in the 90W oil. I found that I could only get about
half of the specified amount in from each side before I began to have
backflow problems, so I just went to the other side and did the same thing.
>hand pump oil can loaded with 90wt and flat screwdriver to gently open the
>hole between rack and boot
>robmgb
John Hubbard
'68 MGB-GT
www.digitalexp.com/~users/ehubbard/mgb-gt.htm
|