--part1_b2.1a69b28.25e06339_boundary
In a message dated 2/19/00 10:32:26 AM Eastern Standard Time,
REasterby@aol.com writes:
<< neilc@apphosting.com >>
Neil, I forgot to mention that the shifter will need to be removed, This will
require access from the interior, remove the aft center rug, shifter cover
sheet metal. This gives access to the 4? mount bolts. also remove the speedo
cable from underneath.
Ray Easterby
72 BGT oo
88 Xj40
--part1_b2.1a69b28.25e06339_boundary
Content-Disposition: inline
Return-Path: <mgs-owner@autox.team.net>
Received: from rly-yd05.mx.aol.com (rly-yd05.mail.aol.com [172.18.150.5]) by
air-yd02.mail.aol.com (v67_b1.24) with ESMTP; Sat, 19 Feb 2000
10:32:26 -0500
Received: from triumph.cs.utah.edu (triumph.cs.utah.edu [155.99.188.52]) by
rly-yd05.mx.aol.com (v67_b1.24) with ESMTP; Sat, 19 Feb 2000 10:32:15
-0500
Received: from localhost (daemon@localhost)
by triumph.cs.utah.edu (8.9.1/8.9.1) with SMTP id IAA13792;
Sat, 19 Feb 2000 08:31:45 -0700 (MST)
Received: (from majordom@localhost)
by triumph.cs.utah.edu (8.9.1/8.9.1) id IAA13765
for mgs-actors; Sat, 19 Feb 2000 08:31:39 -0700 (MST)
From: REasterby@aol.com
Message-ID: <39.1797592.25e0114d@aol.com>
Date: Sat, 19 Feb 2000 10:31:25 EST
Subject: Re: Removing the motor - MGA
To: neilc@apphosting.com
CC: mgs@autox.team.net
MIME-Version: 1.0
X-Mailer: AOL 5.0 for Windows sub 44
Sender: owner-mgs@autox.team.net
Precedence: bulk
Reply-To: REasterby@aol.com
It has been a long time since I pulled an engine out of an A, but a few
things I do remember. Of course, pull the radiator, drive shaft,oil press
hose, water temp gauge tube,starter wiring, tach cable and wiring (mark the
hookups)Drain the oil from the GB and remove the filler dripstick on the GB.
The GB mount bolt can be a pain, oil & swollen mount rubber. Disconnect the
slave cylinder from the GB.Initial lifting at a shallow angle to bring things
forward, then you must change to a steep lift angle to clear the body shroud.
You can jack the front of the car as you lift to help with the steep angle to
clear the body. Good Luck, go slow and be carefull. If you want, I can scan
and email the pages from the BMC Manual.
Ray Easterby
72 BGT orig owner
88 Xj 40
--part1_b2.1a69b28.25e06339_boundary--
|