| To: | mgs@autox.team.net |
|---|---|
| Subject: | Re: Clutch Job 2000 |
| From: | Gonaj@aol.com |
| Date: | Sun, 2 Jan 2000 11:28:37 EST |
Once inside for a clutch I wouldn't think if not replaceing the release bearing. Too much labor for the parts cost involved. Also check for wear on the release lever, the bolt that retyains it and the retainer. I always use an alignment tool, even when I had to cobbel one together for an MGA years ago. Moss has an inexpensive one, 387-235 for the 5 main engine. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Imported British Autos, Ajhsys |
|---|---|
| Next by Date: | Front a-arm rubber bushings, Gonaj |
| Previous by Thread: | Re: Clutch Job 2000, Barney Gaylord |
| Next by Thread: | Re: Clutch Job 2000, RobMGB |
| Indexes: | [Date] [Thread] [Top] [All Lists] |