| To: | MG Board <mgs@autox.team.net> |
|---|---|
| Subject: | Crankshaft Pulley |
| From: | gbaker@customcpu.com (Baker, G.) |
| Date: | Mon, 01 Nov 1999 13:15:13 -0900 |
I need a replacement crankshaft pulley for my 1956 MGA 1500 engine. New ones are about $75 and I truly hate to spend that amount for another one. I'll clean it and make it pretty, I just need one that's not all bent and dinged up. Can I put a speedi-sleeve on a used one to repair wear on the seal surface? If I can what size would I use? Thanks for the time in responding. Gregg Baker Eagle River, Alaska |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | RE: Spoke Wrench?, Hans Duinhoven |
|---|---|
| Next by Date: | Re: "lights on" warning, Jim Stuart |
| Previous by Thread: | Emission contro system, herb lundin |
| Next by Thread: | [mgs] Bill Saidel, walter menge |
| Indexes: | [Date] [Thread] [Top] [All Lists] |