In a message dated 98-02-07 18:07:59 EST, boballen@sky.net writes:
<<
> My Question: Does anyone know of a release agent
> for JB Weld that I could apply to the steering shaft to allow the JB Weld
to
> form to fit inside the wheel yet not allow the wheel and shaft to "become
as
> one"? Does anyone have an alternate way to accomplish this?
Ah, nope. JB Weld is pretty permanent. Why not wrap several turns of teflon
tape
around the splined shaft and push the steering wheel through it?
-- >>
Aluminum foil came to my mind. Of course corrosion between dissimilar metals
could be a long term consequence.
Tom Green
|