| To: | Barney Gaylord <barneymg@juno.com> |
|---|---|
| Subject: | Re: Fine Points of a Valve Job |
| From: | EMILY COWEN <ecowen@cln.etc.bc.ca> |
| Date: | Mon, 5 May 1997 09:21:35 -0700 (PDT) |
Hi Barney Gaylord!! On Sat, 3 May 1997, Barney Gaylord wrote: > Also after installation you have to drill two holes for oil flow. One Barney, I'd advise drilling the oil holes BEFORE reaming/honing the bushings, because the drill bit distorts the bushing locally as it breaks through the surface. EXCELLENT "how to" posting!! TTUL8r, Kirk Cowen |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Duct tape, wire, chewing gum, tools, rope, schnapps.......(MGA), EMILY COWEN |
|---|---|
| Next by Date: | Re: Carlisle Ramblings, Leckstein |
| Previous by Thread: | Re: Fine Points of a Valve Job, Spook37211 |
| Next by Thread: | Re: Fine Points of a Valve Job, EMILY COWEN |
| Indexes: | [Date] [Thread] [Top] [All Lists] |