>Well, I adjusted the pot on my tach to correct any over-reading
>condition per instructions from some helpful folks on this list and it
>helped. Only problem is I reached the limit of adjustment on said pot
>and the reading on the tach is still too high, like 1500 RPM indicated
>at ~750 RPM actual.
> Any ideas?
>
> Thanks
>
>Steve
>
>
>
Find the maximum value of the pot with an ohm meter, then get one with a
higher value at radio shack. Desolder the old one and replace it. problem
solved, cheap too.
Chad
72 B daily driver
|