mgb-v8
[Top] [All Lists]

Re: Left Motor Mount & steering shaft Removal

To: "Kevin & Deana Brown" <MGTRAutoXr@sprintmail.com>
Subject: Re: Left Motor Mount & steering shaft Removal
From: <paul.hunt1@virgin.net>
Date: Mon, 11 Dec 2000 19:43:18 -0000
Cc: <mgs@autox.team.net>, "MGV8 list" <mgb-v8@autox.team.net>
References: <3A327E9F.CE0F6862@sprintmail.com> <3A32B296.83A828E0@erols.com>
Reply-to: <paul.hunt1@virgin.net>
Sender: owner-mgb-v8@autox.team.net
If you don't want to remove the track-rod ends and risk damaging them you
can remove the steering levers from the swivel axles.

PaulH.

----- Original Message -----
From: Jim Stuart <jimbb88@erols.com>
To: Kevin & Deana Brown <MGTRAutoXr@sprintmail.com>
Cc: <mgs@autox.team.net>; MGV8 list <mgb-v8@autox.team.net>
Sent: Saturday, December 09, 2000 10:30 PM
Subject: Re: Left Motor Mount & steering shaft Removal


> The lower shaft is not coming out of the rack without more disassembly
than
> you want to do. You can remove the rack & shaft as a unit after removing
the
> tie rod ends.
>
> The other solution is, as Larry suggests, a cheap combination wrench cut
> short & ground thin. If you are very fortunate, you may be able to find a
> tappet wrench, which is made very thin, & just shorten it so you have room
> to turn it.
>
> Jim Stuart
>
> Kevin & Deana Brown wrote:
>
> > I was all ready to drop in my Buick 215 V8 for a test fit in my ,78 MGB
> > Body shell this morning and the last thing that I was going to do was
> > install the new motor mounts.  Unfortunately I discovered that there is
> > no way to undo the nut on the back of the left side motor mount because
> > of the steering shaft going through the bracket  (which is probably why
> > the previous owner left that mount in place when he redid the body).  I
> > removed the upper part of the steering column and u-joint form the lower
> > steering shaft, but can't get the lower steering shaft to come out of
> > the steering rack.  I was hoping that it would pop out when I pulled on
> > the shaft at the same time that I was tapping on the steering rack, by
> > where the shaft goes in, with a hammer.  Does anyone have any advice??
> > Thanks.
> >
> > Kevin Brown
> > Odessa, MO

<Prev in Thread] Current Thread [Next in Thread>