Guys-
Every time I have bought a clutch/ pressure plate combo, it has included a
throw out bearing that I didn't use, & a plastic alignment tool that I did use.
Try buying from American manufacturers who sell a package. Failing that, try a
wood dowel & a roll of duct tape.
Jim Stuart
Mlandrick@aol.com wrote:
> I already deleted the message, so I don't know who sent it.
>
> I just swapped the clutch in my Rover V8 MGB w/TR8 clutch and transmission,
> and I managed to do it without an alignment tool. It's a bit of a pain, I
> had to line it up a second time, but it wasn't too bad. Before you tighten
> the bolts all the way, do a trial fit with the transmission shaft to make
> sure it's lined up right.
>
> Safety Faster,
>
> Rick
> 75 V8 B
|