| To: | buick-rover-v8@autox.team.net, mgb-v8@autox.team.net |
|---|---|
| Subject: | Bore size |
| From: | dkern@napanet.net (David Kernberger) |
| Date: | Sun, 4 Apr 1999 17:49:40 -0800 |
| Reply-to: | dkern@napanet.net (David Kernberger) |
| Sender: | owner-mgb-v8@autox.team.net |
4/4/99
Question to both groups. What is the maximum bore size that can be
safely used in a Rover 3.9 (241 CI) block. Specifically, can it go to +
.036" to take Chevy 305 pistons (3.736 Bore)? Apparently these sleeves are
thinner than in Rover 3.5 or Buick/Olds F-85 blocks, but how much thinner?
I hope someone can answer this.
Cheers, Dave Kernberger
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | MGB wanted, Jim Stuart |
|---|---|
| Next by Date: | Re: Bore size, Glenn Towery |
| Previous by Thread: | MGB wanted, Jim Stuart |
| Next by Thread: | Re: Bore size, Glenn Towery |
| Indexes: | [Date] [Thread] [Top] [All Lists] |