I have a small leak from my engine as well after rebuilding and installing the
Moss seal. I have not disassembled anything to see where the drip is coming
from. Can someone tell me if the flywheel can be removed with the crankshaft
installed?
Ronald Olds
Sales Manager
Plasser American Corporation
PO Box 5464
2001 Myers Road
Chesapeake, VA 23324-0464
Phone (757) 543-3526
Cell (630) 240-0818
Fax (757) 494-7186
The information contained in this e-mail including any attachments may be
proprietary, privileged or confidential and is intended solely for the use of
the addressee. Any unauthorized distribution, disclosure or any other such use
is strictly prohibited. Furthermore, any reviews, dissemination or copying by
anyone other than the intended recipient is expressly prohibited. If you have
received this e-mail in error, please notify the sender and destroy all copies
of the original transmittal.
-----Original Message-----
From: mg-t-bounces@autox.team.net [mailto:mg-t-bounces@autox.team.net] On
Behalf Of wbeech@flash.net
Sent: Thursday, September 12, 2013 4:34 PM
To: mg-t@autox.team.net
Subject: Re: [Mg-t] TD Engine Pull
Finally getting around to the long-overdue task for replacing the rear main on
the '52TD. What is the consensus of the list as far as the best remedy for
this repair/replacement? I would rather not have to grind the crank to fit
some aftermarket product. Just going to do the seals and the top-end is tight
and there are no other real issues here.
Also, as this is my first MGT engine job where is the best resource, on-line,
to go to for soup-to-nuts guidance?
Many thanks,
Bill
______________________________________________
Mg-t@autox.team.net
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/mg-t/rolds@plausa.com
______________________________________________
Mg-t@autox.team.net
Archive: http://www.team.net/archive
|