There may be replacement parts, but I'm not aware of any immediately.
However, if you remove the rivets, twist the case halves slightly, then
redrill and replace the rivets, you can cause the worn gears to engage more
fully thus saving the reduction box.
Cheers,
Lew Palmer
-----Original Message-----
From: owner-mg-t@autox.team.net [mailto:owner-mg-t@autox.team.net] On Behalf
Of drmoyce
Sent: Monday, November 07, 2005 10:50 AM
To: mg-t@autox.team.net
Subject: Rev counter reduction gearbox
The gears, especially the smaller one, in my tach reduction box are
shot. I think I remember earlier threads on replacements. Anyone have
a source?
Andy Moyce
52 TD Oakland
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|