Douglas
The hole and the 2 bolts were for the early version using the clutch release
cable. There is nothing that covers the hole - or so I was told during my
restoration.
Rick Taylor
MG TD
Cincinnati, OH
----- Original Message -----
From: "Douglas Ormrod" <Douglas.Ormrod@neurological.org.nz>
To: "Mg-T " <mg-t@Autox.Team.Net>
Sent: Sunday, September 26, 2004 5:31 PM
Subject: More Clutch questions
> Thanks to Mark for fixing the server - I shall certainly send a little
> beer money.
>
> I now have my refurbished clutch mechanism working nicely and have
> another couple of questions.
>
> 1. Where the clutch rod comes out of the pedal box (this is a RHD car so
> no cross shaft) it passes through a hole about 1" dia with a couple of
> threaded holes on either side. I assume this is to take some kind of
> dust and water excluding gaiter; but I can't see anything in the parts
> books. What should go here?
>
> 2. The new Moss return spring has a right angled end and a hook end -
> the right angled end goes nicely through the little hole on the pivot
> lever - do I need to bend this over or is the tension enough to hold it
> in place?
>
> Thanks
>
> Douglas
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|