Bud:
<<<snip>>>
torquing down the bolts that fasten the pressure plate (8") to
flywheel?
<<<snip>>>
W.K.F. Woods book says 32 lbs./ft.
The MGA Workshop manual says 25 lbs./ft. A MGA clutch cover will fit
the TD as I have one in my TD. They have heavier pressure springs.
These are 8x1.00 mm bolts. A grade ten 8 mm bolt is normally torqued to
22 lbs./ft. and grade 12 is 27 lb./ft.
If it were me and I were using the original bolts, then I'd stick with
the MGA recommendation of 25 lbs./ft.
Blake
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|