Ray,
I believe that this was discussed on the T ABC list, however as my
axle is approximately .004" oversize and I wouldn't be removing much
material
my preference would be to ream rather than hammer shrink.
Thanks,
Bill Putnam
not necessarily on imperial business, just trying to maintain the
breed...
At Wednesday, 9 July 2003, "Ray" <spook01@comcast.net> wrote:
>Didn't someone on the TABC list hammer-shrink the axle eyes to standard??
>
>RECIDITE, PLEBES! GERO REM IMPERIALEM!,
>Ray
> ----- Original Message -----
> From: Bill Putnam
> To: mg-mmm@autox.team.net
> Cc: bputnam@ci.madison.wi.us
> Sent: Wednesday, July 09, 2003 3:43 PM
> Subject: searching for oversize J2 king pins
>
> I just obtained an axle for my J2. One eye is slightly egg shaped
> and I am told that a common repair is to ream the axle eye to 16
> mm and install oversize king pins (ream spindle bushes to suit as
> well). Does anyone know where I can obtain oversize king pins to
> suit?
>
> Thank you,
>
> Bill Putnam
>
> /// unsubscribe/change address requests to majordomo@autox.team.
net or
>try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/mg-mmm
> /// Send list postings to mg-mmm@autox.team.net
>
>/// unsubscribe/change address requests to majordomo@autox.team.
net or try
>/// http://www.team.net/cgi-bin/majorcool
>/// http://www.team.net/mailman/listinfo
>/// Archives at http://www.team.net/archive/mg-mmm
>/// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|