| To: | <DENKLEMM@aol.com>, <mg-mmm@autox.team.net> |
|---|---|
| Subject: | Re: P type engine |
| From: | "Dave & Diana Dwyer" <dmdwyer@optusnet.com.au> |
| Date: | Wed, 7 May 2003 17:36:56 +1000 |
| References: | <11c.21ef6dde.2be90c1a@aol.com> |
| Reply-to: | "Dave & Diana Dwyer" <dmdwyer@optusnet.com.au> |
| Sender: | owner-mg-mmm@autox.team.net |
Dennis I used a 'sealed for life' bearing - the part number is suffixed 2RS, for 'two rubber seal'. I don't think there is any difference between PA and PB heads. Regards Dave Dwyer J2, TA, TC Sydney /// unsubscribe/change address requests to majordomo@autox.team.net or try /// http://www.team.net/cgi-bin/majorcool /// http://www.team.net/mailman/listinfo /// Archives at http://www.team.net/archive/mg-mmm /// Send list postings to mg-mmm@autox.team.net |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | P-type distributor, Anderson, Phil |
|---|---|
| Next by Date: | searching for good used J2 front axle, Bill Putnam |
| Previous by Thread: | P type engine, DENKLEMM |
| Next by Thread: | Re: P type engine, TATERRY |
| Indexes: | [Date] [Thread] [Top] [All Lists] |