In a message dated 11/14/2002 1:31:45 PM Central Standard Time, DENKLEMM
writes:
> Let me try to be clearer. The block that came out of my PA is a single
> breather. The pistons that came out of it measure 2.359" (60 mm is 2.362" &
> 57 mm is 2.244") My pistons are already .118 oversize. The machine shop
> wants to bore it out .020 more. The bore of the block has an .008" taper.
> Could this be a PB block and how do I tell the difference? What do I have
> here?
> Thanks
> Dennis
> PA1518
Dennis,
You have answered your own question, if it's a single breather it's a PA
block. Period.
I don't know of an early PA block being bored out to 60mm. Perhaps your best
bet would be to re-sleeve it to 57mm with over size pistons in the 57mm
range.
Any one have experience with this?
Brian Kelly
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|