Hi Dennis,
to remove a P or N engine breather, soak it for a night
with WD 40 or similar, and than tap it gently right-left-right - -
with a light plastic-hammer.
When the engine is dismantled, you can push it from
inside with a round shaped tool.
In case you ruin it :
Sports&Vintage Motors No. 1910
MOSS Europe Ltd. No. PW 807
But both are only similar to the original and
sometimes made of brass. So be careful !
Gerhard
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Hi All,
Next question. How do you remove the breather from the block? Is it just
pushed in? Are there mew replacement breathers available in case I mess this
one up? This engine has a single breather, if that makes a difference.
Thanks much
Dennis
PA1518
/
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|