| To: | LSR <land-speed@autox.team.net> |
|---|---|
| Subject: | GM 3 Bar MAP Sensor |
| From: | drmayf <drmayf@mayfco.com> |
| Date: | Mon, 29 Aug 2005 16:41:37 -0700 |
Does anyone have any particulars regarding the use of a GM MAP sensor (2 or 3 bar) as a boost pressure measuring device? I have a 5 volt reference signal available and can log 0 to 5 volts (more if I use a resistor dividing circuit). What does the MAP sensor need? I see power, ground and signal return: what volts does it need? mayf |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Rule 1H Question.., drmayf |
|---|---|
| Next by Date: | RE: GM 3 Bar MAP Sensor, Dave Dahlgren |
| Previous by Thread: | Rule 1H Question.., drmayf |
| Next by Thread: | RE: GM 3 Bar MAP Sensor, Dave Dahlgren |
| Indexes: | [Date] [Thread] [Top] [All Lists] |