Re: Quick Data Connectors

["Bill Pokey Bennett" <bennevl@bellsouth.net>]

Russ,
yeah maybe I should have mentioned how big our heat treat furnaces are. I
think last time I measured they were close to 70 feet long. We use them to
mass treat large numbers of valve lifter rollers and tripod bearings.
Without proper equipment it would be impossible to accurately calibrate the
data acq. I was just thinking about establishing some sort of base line to
go by. Granted he has already been running this system for some time, but it
wouldn't hurt to check it once a year at least. Oh I can hear it now. You
would know when a sensor was reading bad cause of the bad data collected.
Yeah but that is one run wasted the data is useless and a motor only has so
many runs in it right Keith.

I was thinking more along the lines of simulating the analog inputs along a
series of points to verify the A/D conversions.  Just a simple test to
verify everything was normal. Hey wait a minute what is normal?

Bill
"Garbage in equals Garbage out"

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.