Re: Welding vs Brazing

[Nt788@aol.com]

In a message dated 1/8/2003 12:31:41 AM Pacific Standard Time, 
albaugh_neil@ti.com writes:

<< Many high-dollar custom bike frames are fillet brazed, as were some
 motorcycles (Rickman, for one), and race car chassis. It seems as if fillet
 brazing was far more widely used in the UK than in the USA.
 
 I hope this may help. >>
That was great but confusing when repairing one! JACK

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.