Folks,
Sorry if this is a repeat but I sent it yesterday and did
not see it show up. Again, sorry if this is a dup.
***
I am putting a Ford 9" under the rear-end of a 85 corvette and need to put
together a set of coil overs for the suspension. Since this is my first
experience with coil over, there are lots of things I don't understand.
1st... some shocks are rebuildable/revalvable.... Do I care in a Bonneville
application? Do they get enough used over a few seasons to make this
something I need?
2nd... Springs come in variable rate and standard?' Again, are their pros
and cons for my application?
3rd... Since I am taking out a transverse leaf spring rear-end system, any
starting guess' as to what weight springs I need? When the car is
finished, the total car will be ~3500 lbs before we start playing with
ballast (if any).
**************
As I side note, I sent Ed a private message asking about coil overs on the
FRONT of his Vette, but if anyone else would like to chip in a comment or
two on that issue, I would love to hear form them as well.
KEN
In far Northern Calif. it is way, way wet... but then some of us just
consider it self-shoveling snow :-). Hope you folks with really bad
weather are making out OK.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* Ken Bond, *
* Prof. of Bus. Admin. *
* Humboldt State Univ. ____________ *
* Arcata, CA 95521 _______| 58 85 99 |_________ *
* / How much horsepower / *
* / Can I have and still / *
* Wk.:707.826.4277 /_________ go to Heaven?______/ *
* Wk Fax:707.826.6666 |_61______61_| *
* Hm.:707.826.7764 I Never Drive Faster than *
* Hm Fax:707.826.0334 My Guardian Angel Can Fly *
* Internet: *
* kmb2@humboldt.edu (office) *
* ragtops@humboldt1.com (home) *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
|