Best to remove the bearing first to make sure you get the right
replacement. There might be variations. The numbers are usually on the
side of the outer ring. It will most likely be a standard bearing .
Could be metric. Often used on dynamo's are metric SKF/TIMKEN/FAG etc
6202-2RS or 627-2RS check first.
Kees Oudesluijs
Op 29-7-2023 om 17:22 schreef Harold Manifold:
> My dynamo is giving me the signal it is time for a new front bearing.
> Does anyone know the universal bearing number for a Sealed Ball
> Bearing to replace "Bearing - drive end 7H5021"?
>
> Thanks.... Harold
>
--
Dit e-mailbericht is met AVG-antivirussoftware gecontroleerd op virussen.
www.avg.com
_______________________________________________
Archive: http://www.team.net/pipermail/healeys
http://autox.team.net/archive/healeys
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|