No, if the two set screws are in the holes they will limit the movement of the
shift lever, allowing fore and aft but not side to side. The tip should rest in
the bottom of the slot in neutral.
P
Sent from my iPhone
> On Oct 19, 2021, at 12:43 PM, rfbegani@gmail.com wrote:
>
> Great picture, thanks.. So you are indicating that the tip should enter
> the
> hole in the shaft?
>
> -----Original Message-----
> From: Healeys <healeys-bounces@autox.team.net> On Behalf Of Perry Small via
> Healeys
> Sent: Tuesday, October 19, 2021 8:36 AM
> To: Healeys <healeys@autox.team.net>
> Subject: [Healeys] Healey Shift Stick
>
> Bolt - including tip- 3/4 inch thread below head Tip - diameter 0.20 inch
> Length 0.25 inch
>
>
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|