--===============5814974757052042474==
boundary="=_d4509fdbeed1239e8d44daaeca8a2154"
--=_d4509fdbeed1239e8d44daaeca8a2154
Content-Transfer-Encoding: quoted-printable
Michael-there is none. Use a big 1-1/2" wrench and tighten to a good=0A1=
00lbs...tight. then bend the tab washer flat to hold the position.=0ALoc=
k the crank with a block of wood (pan off) while tightening. Hank=0A=0A=
=09-----------------------------------------From: "Michael MacLean" =0AT=
o: "Ahealey help"=0ACc: =0ASent: Saturday July 10 2021 9:00:15PM=0ASubje=
ct: [Healeys] Crankshaft Nut=0A=0A I can't seem to find the torque setti=
ng for the crankshaft nut at the=0Apulley for my BN2. Mike MacLean
--=_d4509fdbeed1239e8d44daaeca8a2154
Content-Transfer-Encoding: quoted-printable
<html><body>Michael-there is none. Use a big 1-1/2" wrench and tig=
hten to a good 100lbs...tight. then bend the tab washer flat to hold the=
position. Lock the crank with a block of wood (pan off) while tig=
htening. Hank<br><br><div class=3D"reply-new-signature"></div><p>-------=
----------------------------------</p>From: "Michael MacLean" <springer.=
mike51@gmail.com><br>To: "Ahealey help"<br>Cc: <br>Sent: Saturday July 1=
0 2021 9:00:15PM<br>Subject: [Healeys] Crankshaft Nut<br><br>=0A<div>I c=
an't seem to find the torque setting for the=0Acrankshaft nut at the pul=
ley for my BN2.=0A<div>Mike MacLean</div>=0A</div>=0A</springer.mike51@g=
mail.com></body></html>
--=_d4509fdbeed1239e8d44daaeca8a2154--
--===============5814974757052042474==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
--===============5814974757052042474==--
|