I did it once, similar to what you've tried, but with 2 - 1/8" steel
rods. I either flattened, or ground one end of each rod, then bent the
tip 90deg as a hook. You want to push the rods up with the 'hooks'
facing away from the rocker shaft, so that it grabs inside the steel
sleeve of the seal to pull it out. Then, you can use the unflattened
ends to tap the new seal in.
I think most people now use a couple of the thinner seals, as the
proper, original-type seal is unavailable (I bought a spare from Gary
Hemphill way back when).
Bob
On 2/11/2021 12:27 PM, Roger Grace via Healeys wrote:
> Trying to replace the steering box oil seal on my BJ8 in situ.
> Using modified pitman puller managed to get the arm off.
> Now struggling to get the old oil seal out.
> Any ideas/techniques appreciated ?
> Only about 1/8 in gap between splines and housing.
> Been making small hook with steel rod (bike spoke) but can"t get grip
> on the steel ring.
> Fellow AH person suggested drilling hole and inserting a screw to pull
> on ?
> All thoughts appreciated.
> rg
>
>
_______________________________________________
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|